Change place and contents
Added IP addresses setting examples for Hot stand-by,
PRP, and HSR operations
Modified the notes written below Fig. 13.3-2 to allow
changing the rated current
Added the contents about how to change rated current
using the VCT and GR-TIEMS
Revised the rated current selectable
Corrected and added the blocking ARC signal in Figure
2.20-2&3 of CBF
Corrected the FSRY_OP signal coming from FS
function in Fig. 2.33-3 in TRC
Corrected Equation (4.6-14) and the meaning of CB
advance time in SYNDIF
Corrected the contents about implementation rule of
100Base-FX when single LAN port is selected.
Revised the FG cables on BI2A module in Fig 5.4-8
Refined the contents about PLC data error
Corrected the table about COM modules
Revised the contents about Z*S/G-MSDET settings
used in multi-phase fault in Sec. 2.1.3(ii)-3/(iii)-2
Corrected DIFLFS-EN switch typo in check relay logic
of Figure 2.2-4
Corrected the Z1G, Z1XG, and Z5G logics regarding
MFP_Blk scheme in Fig 2.10-44, 45, and 49
Corrected the order of setting items about threshold,
delay time, and pick-up ratio in OV setting table
Corrected the order of setting items about threshold,
delay time, and pick-up ratio in OVS setting table
Corrected the order of setting items about threshold,
delay time, and pick-up ratio in OVG setting table
Revised Default settings in Table 8.1-2, 8.2-1/-2/-3, 8.3-
3/-4.
Corrected the number of digits for metering in Table
8.2-3
Corrected the direction of inequality symbol in Eq.
(10.2-3) and (10.2-4)
Revised the corresponding table for PRP/HSR/RSTP
protocol
Corrected 61850 attributes ‘Good & Questionable’
regarding ‘Alarm and Warning’ in Table 11.3-5
Revised the selection for PRP/HSR/RSTP protocol in
Ordering sheet
Deleted 34&35 software code from Function table list
in Ordering sheet
Added information about the data required in WDE
being transferred at N=3 data frame
Corrected information about the explanation at
Equation 2.4-4 in CT saturation in DIFL
To Next Page
Loading...
