Toshiba GR200 Series - 3.6.4 Settings in LED logics; (i) Settings using GR-TIEMS; (ii) Settings using IED screen

6F2S1914 (0.49)
GRL200 (Soft 033 & 037)
- 582 -
monitoring application: Control hierarchy . “LEDR01_CTRL_RIGHT” is provided
in Table 3.6-3.
3.6.4 Settings in LED logics
The user can program the status and the signal of the LED, so that the LEDs are possible to
switch off upon occurrence of the reset. As shown in the logic relating to the LED†, each logic
has a timer and a setting; accordingly, setting Latch should be set for the operation of the
LEDR function. Additionally, the user should connect the signal LED_RST_CMD with the LED
logic.
†Note: For more information on LED logics, see Chapter Technical description: Human
machine interface: LED indicators .
(i) Settings using GR-TIEMS
Figure 3.6-9 shows how to connect the reset signal LED_RST_CMD for the LED-03 logic. The
user can assign a reset signal for the respective LED logics by the drag and drop operation.
The user should also select Latch for the behavior from the pull-down menu.
Set [Behavior] to Latch
Choose the signal
LED_RST_CMD for the
LED-03 logic
Figure 3.6-9 Settings for LED-03 circuit provided by “Setting I/O menu” of GR-TIEMS
(ii) Settings using IED screen
The operation from the IED screen can also be set. See Chapter User interface: I/O setting sub-
menu .