- 595 -
(iii) Signal name and number
Note: The user should note the following descriptions shown in the column “M/O” for
each table:
“O” indicates that the signal is provided for optional use.
“M” indicates that the user should map/set/configure the signal; otherwise, the
user may experience an operational failure if the default settings are
used.
“N/A” indicates that the user cannot change the state of the signal.
Table 3.7-2 Mapping points for the reception of control command
GCNT01 control request(Mapping data)
GCNT02 control request(Mapping data)
GCNT03 control request(Mapping data)
GCNT32 control request(Mapping data)
Table 3.7-3 Input signals to condition logic
Command Blocking status ( Off / Blocked)
Automatic sequence control is in progress.
Double Command Blocking(DCB) is in progress.
Travelling events are detected.
Table 3.7-4 PLC Connection point (Input signals from the control hierarchy logic)
Control hierarchy for GCNT01–32
Table 3.7-5 PLC Monitoring points (Signal “select complete/ failed” for BIO)
GCNT01 Selection completed (Mapping)
GCNT02 Selection completed (Mapping)
GCNT03 Selection completed (Mapping)
GCNT32 Selection completed (Mapping)
Table 3.7-6 PLC Monitoring points (Signal “stSeld” for BIO)
GCNT01 count change selected signal(stSeld) for SAS
GCNT02 count change selected signal(stSeld) for SAS
GCNT03 count change selected signal(stSeld) for SAS
To Next Page
Loading...
