- 653 -
Table 4.1-19 PLC monitoring points (signals with in operate logic)
SPOS01 on direction execute command
SPOS02 on direction execute command
SPOS03 on direction execute command
SPOS20 on direction execute command
SPOS01 off direction execute command
SPOS02 off direction execute command
SPOS03 off direction execute command
SPOS20 off direction execute command
Table 4.1-20 PLC monitoring points (Output signal for response)
SPOS01 execute fail signal by fixedlogic
SPOS02 execute fail signal by fixedlogic
SPOS03 execute fail signal by fixedlogic
SPOS20 execute fail signal by fixedlogic
(ix) Setting names
Note: The “xx” of “SPOSxx” represents the SPOS function number. (e.g., if the SPOS03
is considered, the “xx” is equal to “03”. The suffix “xx” can be represented by either
a “01” to “20”).
Table 4.1-21 Setting of Operate in SPOSxx
Method of command output(SPOS01-20)
Duration of command output(SPOS01-20)
Detection time for terminating control (SPOS01-20)
Logic selector for operate condition (SPOS01-20)
Logic selector for command output (SPOS01-20)
Activate control function of SPOS01-20
Logic selector for operate condition (SPOS01-20)
To Next Page
Loading...
