- 667 -
4.1.7 Signal
◆ Signal monitoring points in SPOS01
SPOS01(FunctionID:510001)
SPOS multi select check signal for Auto sequence
SPOS01 selected signal(stSeld) for SAS
SPOS01 execute binary output signal for SAS
SPOS01 travelling info for control
SPOS01 select or execute command received
SPOS01 control event data (selected)
SPOS01 control event data (select fail)
SPOS01 control event data (select release)
SPOS01 control event data (execute output on)
SPOS01 control event data (execute command ng)
SPOS01 control event data (execute fail)
SPOS01 select command by OWS(HMI)
SPOS01 select command by RCC
SPOS01 select command by Remote
SPOS01 select command by LCD
SPOS01 execute command by OWS(HMI)
SPOS01 execute command by RCC
SPOS01 execute command by Remote
SPOS01 execute command by LCD
SPOS01 execute command by PLC
SPOS01 selected condition signal
SPOS01 select release condition signal
SPOS01 off direction execute command OK condition signal by fixedlogic
SPOS01 on direction execute command OK condition signal by fixedlogic
SPOS01 off direction execute command OK condition signal
SPOS01 execute complete signal
SPOS01 select command mode err
SPOS01 execute command mode err
SPOS01 no direction select condition signal 06
SPOS01 selected condition signal 04
SPOS01 off direction execute binary output signal
SPOS01 no direction select fail condition signal
SPOS01 on direction execute command OK condition signal
SPOS01 off direction execute command fail condition signal by fixedlogic
SPOS01 on direction execute command fail condition signal by fixedlogic
SPOS01 execute command fail factor signal except interlock/synchronism check
SPOS01 off direction select condition signal 21
SPOS01 on direction execute binary output signal
SPOS01 off direction execute command fail condition signal
SPOS01 no direction select condition signal 10
SPOS01 on direction execute command fail condition signal
To Next Page
Loading...
