- 745 -
Control hierarchy condition in SOFTSW61 (S43-61)
Table 4.3-6 Mapping points for the command reception in SOFTSWx
Control command received in CBK
Control command received in ICB
Control command received in SCB
Control command received in SOFTSW1 (S43-01)
Control command received in SOFTSW2 (S43-02)
Control command received in SOFTSW3 (S43-03)
Control command received in SOFTSW61 (S43-61)
Table 4.3-7 Mapping points for the output signals of SOFTSWx
Selection completed signal in CBK
Selection completed signal in ICB
Selection completed signal in SCB
Selection completed signal in SOFTSW1 (S43-01)
Selection completed signal in SOFTSW2 (S43-02)
Selection completed signal in SOFTSW3 (S43-03)
Selection completed signal in SOFTSW61 (S43-61)
Table 4.3-8 Input signals for condition logic
Double Command Blocking (DCB) is in progress.
Travelling events are detected.
(This is setting of CMNCTRL)
Automatic sequence control is in progress.
Table 4.3-9 PLC monitoring points (ON and OFF selection completion)
On Selection completed in CBK
On Selection completed in ICB
On Selection completed in SCB
On Selection completed in SOFTSW1 (S43-01)
On Selection completed in SOFTSW2 (S43-02)
On Selection completed in SOFTSW3 (S43-03)
On Selection completed in SOFTSW61 (S43-61)
Off Selection completed in CBK
Off Selection completed in ICB
Off Selection completed in SCB
Off Selection completed in SOFTSW1 (S43-01)
Off Selection completed in SOFTSW2 (S43-02)
Off Selection completed in SOFTSW3 (S43-03)
To Next Page
Loading...
