- 929 -
TPOS03 control hierarchy condition(PLC#3)
TPOS24 control hierarchy condition(PLC#3)
Table 4.9-9 PLC monitoring points (Output signal for select condition logic)
TPOS01 select command mode is invalid.
TPOS02 select command mode is invalid.
TPOS03 select command mode is invalid.
TPOS24 select command mode is invalid.
Event suppression detected (TPOS01)
Event suppression detected (TPOS02)
Event suppression detected (TPOS03)
Event suppression detected (TPOS24)
BI connection error detected(TPOS01)
BI connection error detected(TPOS02)
BI connection error detected(TPOS03)
BI connection error detected(TPOS24)
Table 4.9-10 PLC monitoring points (Output signal for BIO)
Select command (P1) for Binary Output in TPOS01
Select command (P1) for Binary Output in TPOS02
Select command (P1) for Binary Output in TPOS03
Select command (P1) for Binary Output in TPOS24
Select command (P2) for Binary Output in TPOS01
Select command (P2) for Binary Output in TPOS02
Select command (P2) for Binary Output in TPOS03
Select command (P2) for Binary Output in TPOS24
Select command (P3) for Binary Output in TPOS01
Select command (P3) for Binary Output in TPOS02
Select command (P3) for Binary Output in TPOS03
Select command (P3) for Binary Output in TPOS24
(xii) Setting names
Table 4.9-11 Settings for ‘SBO control in TPOSxx
Activation of the control function in TPOS01–24
Logic selector for select condition (TPOS01–24)
Equipment(EDS or 43SW) type selector
Activation for the panel control locally (TPOS01–24)
Note: The “xx” within “TPOSxx” represents the function number. If TPOS03 is
considered, “xx” is equal to “03”. The suffix “xx” can be represented from 01 to 24.)
To Next Page
Loading...
