Toshiba H7 - Page 127

120 H7 ASD Operation Manual
Speed Loop Integral Gain
Program ⇒ Feedback Parameters ⇒ PG Settings
This parameter sets the response time of the Speed Loop Integral Gain. The
smaller the value here, the more pronounced (quicker) the effect of the integral
function.
Direct Access Number — F377
Parameter Type — Numerical
Factory Default — (drive dependent)
Changeable During Run — Yes
Minimum — 10.0
Maximum — 200.0
Motor Counter Data
Program ⇒ Feedback Parameters ⇒ PG Settings
Contact Toshiba’s Marketing Department for information on this parameter.
Direct Access Number — F378
Parameter Type — Selection List
Factory Default — Selection 0
Changeable During Run — No
Minimum — Selection 0
Maximum — Selection 5
Speed Loop Parameter Ratio
Program ⇒ Feedback Parameters ⇒ PG Settings
Contact Toshiba’s Marketing Department for information on this parameter.
Direct Access Number — F379
Parameter Type — Numerical
Factory Default — 1.00
Changeable During Run — No
Minimum — 0.01
Maximum — 10.00
Use Speed Mode
Program ⇒ Pattern Run Control Parameters ⇒ Preset Speed Mode
This parameter Enables/Disables the Use Speed mode. When enabled, the
system uses all of the parameter settings of the Preset Speed being run.
Otherwise, only the frequency setting is used.
Direct Access Number — F380
Parameter Type — Check Box
Factory Default — Disabled
Changeable During Run — No
Preset Speed Direction #1
Program ⇒ Pattern Run Control Parameters ⇒ Preset Speeds
Determines the forward/reverse setting for the #1 Preset Speed (F018).
Direct Access Number — F381
Parameter Type — Selection List
Factory Default — Forward
Changeable During Run — No
Preset Speed Direction #2
Program ⇒ Pattern Run Control Parameters ⇒ Preset Speeds
Determines the forward/reverse setting for the #2 Preset Speed (F019).
Direct Access Number — F382
Parameter Type — Selection List
Factory Default — Forward
Changeable During Run — No
F377 F382
www . ElectricalPartManuals . com