Toshiba H7 - Page 128

H7 ASD Operation Manual 121
Preset Speed Direction #3
Program ⇒ Pattern Run Control Parameters ⇒ Preset Speeds
Determines the forward/reverse setting for the #3 Preset Speed (F020).
Direct Access Number — F383
Parameter Type — Selection List
Factory Default — Forward
Changeable During Run — No
Preset Speed Direction #4
Program ⇒ Pattern Run Control Parameters ⇒ Preset Speeds
Determines the forward/reverse setting for the #4 Preset Speed (F021).
Direct Access Number — F384
Parameter Type — Selection List
Factory Default — Forward
Changeable During Run — No
Preset Speed Direction #5
Program ⇒ Pattern Run Control Parameters ⇒ Preset Speeds
Determines the forward/reverse setting for the #5 Preset Speed (F022).
Direct Access Number — F385
Parameter Type — Selection List
Factory Default — Forward
Changeable During Run — No
Preset Speed Direction #6
Program ⇒ Pattern Run Control Parameters ⇒ Preset Speeds
Determines the forward/reverse setting for the #6 Preset Speed (F023).
Direct Access Number — F386
Parameter Type — Selection List
Factory Default — Forward
Changeable During Run — No
Preset Speed Direction #7
Program ⇒ Pattern Run Control Parameters ⇒ Preset Speeds
Determines the forward/reverse setting for the #7 Preset Speed (F024).
Direct Access Number — F387
Parameter Type — Selection List
Factory Default — Forward
Changeable During Run — No
Preset Speed Direction #8
Program ⇒ Pattern Run Control Parameters ⇒ Preset Speeds
Determines the forward/reverse setting for the #8 Preset Speed (F287).
Direct Access Number — F388
Parameter Type — Selection List
Factory Default — Forward
Changeable During Run — No
Preset Speed Direction #9
Program ⇒ Pattern Run Control Parameters ⇒ Preset Speeds
Determines the forward/reverse setting for the #9 Preset Speed (F288).
Direct Access Number — F389
Parameter Type — Selection List
Factory Default — Forward
Changeable During Run — No
Preset Speed Direction #10
Program ⇒ Pattern Run Control Parameters ⇒ Preset Speeds
Determines the forward/reverse setting for the #10 Preset Speed (F289).
Direct Access Number — F390
Parameter Type — Selection List
Factory Default — Forward
Changeable During Run — No
F383 F390
www . ElectricalPartManuals . com