Toshiba H7 - Page 131

124 H7 ASD Operation Manual
Number of Poles of Motor
Program ⇒ Motor Parameters ⇒ Motor Settings
This parameter identifies the number of motor poles.
Direct Access Number — F411
Parameter Type — Numerical
Factory Default — 4
Changeable During Run — No
Minimum — 2
Maximum — 16
Motor Capacity
Program ⇒ Motor Parameters ⇒ Motor Settings
This parameter identifies the wattage rating of the motor.
Direct Access Number — F412
Parameter Type — Numerical
Factory Default — (drive dependent)
Changeable During Run — No
Minimum — 0.10
Maximum — (drive dependent)
Units — kW
Motor Type
Program ⇒ Motor Parameters ⇒ Motor Settings
This parameter identifies the type of motor being used.
Settings:
Toshiba EQP III TEFC
Toshiba EQP III ODP
Toshiba EPACT TEFC
Toshiba EPACT ODP
Other Motor
Direct Access Number — F413
Parameter Type — Selection List
Factory Default — Toshiba EQP III
TEFC
Changeable During Run — No
Allow Autotune
Program ⇒ Motor Parameters ⇒ Vector Motor Model
This parameter Enables/Disables the Autotune function.
Direct Access Number — F414
Parameter Type — Check Box
Factory Default — Enable
Changeable During Run — No
Torque Command
Program ⇒ Torque Setting Parameters ⇒ Torque Control
When operating in the Torque Control mode, this parameter allows the user to
select the source of the torque command signal.
Settings:
VI/II
RR
RX
RX2 (option)
LED Keypad Option
Binary/BCD Input
Common Serial (TTL)
RS232/485
Communication Card
Direct Access Number — F420
Parameter Type — Selection List
Factory Default — RX
Changeable During Run — Ye s
F411 F420
www . ElectricalPartManuals . com