Toshiba H7 - Page 136

H7 ASD Operation Manual 129
Driving Torque Limit #1
Program ⇒ Torque Setting Parameters ⇒ Manual Torque Limit
Settings
This parameter provides a value for the Power Running Torque Limit #1
setting if Setting is selected at F440. This value provides the positive torque
upper limit for the #1 motor.
Direct Access Number — F441
Parameter Type — Numerical
Factory Default — 250.0
Changeable During Run — Ye s
Minimum — 0.00
Maximum — 250.0
Units — %
Regeneration Torque Limit #1
Program ⇒ Torque Setting Parameters ⇒ Torque Limit Settings
This parameter determines the source of the Regenerative Torque Limit
control signal. If Setting is selected, the value set at F443 is used for this
parameter.
Settings:
VI/II
RR
RX
RX2 (option)
Setting
Direct Access Number — F442
Parameter Type — Selection List
Factory Default — Setting
Changeable During Run — Ye s
Regeneration Torque Limit Setting #1
Program ⇒ Torque Setting Parameters ⇒ Torque Limit Settings ⇒
Manual Settings
This parameter provides a value to be used as the Regeneration Torque Limit
#1 if Setting is selected at F442.
Direct Access Number — F443
Parameter Type — Numerical
Factory Default — 250.0
Changeable During Run — Ye s
Minimum — 0.00
Maximum — 250.0
Units — %
Driving Torque Limit #2
Program ⇒ Torque Setting Parameters ⇒ Manual Torque Limit
Settings
This parameter is used to set the positive torque upper limit for the #2 motor
profile when multiple motors are controlled by a single drive or when a single
motor is to be controlled by multiple profiles.
Direct Access Number — F444
Parameter Type — Numerical
Factory Default — 250.0
Changeable During Run — Ye s
Minimum — 0.00
Maximum — 250.0
Units — %
F441 F444
www . ElectricalPartManuals . com