Toshiba H7 - Page 53

46 H7 ASD Operation Manual
Special Control Parameters
Crane/Hoist Load
Light-load High-speed Operation Load
Detection Time
N/A
Light-load High-speed Operation Heavy Load
Detection Time
N/A
Switching Load Torque During Forward Run N/A
Heavy Load Torque During Acceleration in
the Forward Direction
N/A
Heavy Load Torque During Deceleration in
the Forward Direction
N/A
Switching Load Torque During Reverse Run N/A
Heavy Load Torque During Acceleration in
the Reverse Direction
N/A
Heavy Load Torque During Deceleration in
the Reverse Direction
N/A
Frequency for Automatic High-speed
Operation at Light Load
N/A
Backlash Setup Not available at the time of this release. N/A
V/f Five Point Setting
#1 Frequency Setting F190
#1 Voltage Setting F191
#2 Frequency Setting F192
#2 Voltage Setting F193
#3 Frequency Setting F194
#3 Voltage Setting F195
#4 Frequency Setting F196
#4 Voltage Setting F197
#5 Frequency Setting F198
#5 Voltage Setting F199
Special Parameters
V/f Adjustment Coefficient F183
0 Hz Dead Band Frequency Setting Signal F244
0 Hz Command Stop Function F255
Over Exciting Cooperation F481
Stall Cooperation Gain at Field Weakening
Zone
N/A
Exciting Starting Rate N/A
Compensation Coefficient for Iron Loss F487
Voltage Compensation Coefficient for Dead
Time
N/A
Dead Time Compensation Enable/Disable F489
Program Menu Navigation
Primary Menu Sub Menu Parameter Name
Parameter
Number
www . ElectricalPartManuals . com