Toshiba H9 ASD - Page 188

H9 ASD Installation and Operation Manual 181
Preset Speed 4 Operation Mode
Program Pattern Run Operation Mode
Same as Preset Speed 1 Operation Mode (see F561).
Direct Access Number — F564
Parameter Type — Selection List
Factory Default — Forward Run
Changeable During Run — No
Preset Speed 5 Operation Mode
Program Pattern Run Operation Mode
Same as Preset Speed 1 Operation Mode (see F561).
Direct Access Number — F565
Parameter Type — Selection List
Factory Default — Forward Run
Changeable During Run — No
Preset Speed 6 Operation Mode
Program Pattern Run Operation Mode
Same as Preset Speed 1 Operation Mode (see F561).
Direct Access Number — F566
Parameter Type — Selection List
Factory Default — Forward Run
Changeable During Run — No
Preset Speed 7 Operation Mode
Program Pattern Run Operation Mode
Same as Preset Speed 1 Operation Mode (see F561).
Direct Access Number — F567
Parameter Type — Selection List
Factory Default — Forward Run
Changeable During Run — No
Preset Speed 8 Operation Mode
Program Pattern Run Operation Mode
Same as Preset Speed 1 Operation Mode (see F561).
Direct Access Number — F568
Parameter Type — Selection List
Factory Default — Forward Run
Changeable During Run — No
Preset Speed 9 Operation Mode
Program Pattern Run Operation Mode
Same as Preset Speed 1 Operation Mode (see F561).
Direct Access Number — F569
Parameter Type — Selection List
Factory Default — Forward Run
Changeable During Run — No
Preset Speed 10 Operation Mode
Program Pattern Run Operation Mode
Same as Preset Speed 1 Operation Mode (see F561).
Direct Access Number — F570
Parameter Type — Selection List
Factory Default — Forward Run
Changeable During Run — No
Preset Speed 11 Operation Mode
Program Pattern Run Operation Mode
Same as Preset Speed 1 Operation Mode (see F561).
Direct Access Number — F571
Parameter Type — Selection List
Factory Default — Forward Run
Changeable During Run — No
Preset Speed 12 Operation Mode
Program Pattern Run Operation Mode
Same as Preset Speed 1 Operation Mode (see F561).
Direct Access Number — F572
Parameter Type — Selection List
Factory Default — Forward Run
Changeable During Run — No
Preset Speed 13 Operation Mode
Program Pattern Run Operation Mode
Same as Preset Speed 1 Operation Mode (see F561).
Direct Access Number — F573
Parameter Type — Selection List
Factory Default — Forward Run
Changeable During Run — No
F564 F573
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net