254 H9 ASD Installation and Operation Manual
Enclosure and Conduit Plate Dimensions
The H9 ASD part numbering convention is shown below.
The enclosure dimensions for the available models (typeforms) are listed in Tables 16 and 17. The conduit
plates referenced are shown in Figures 34, 35, and 36.
H9
Part Numbering Convention.
Note: The Type 1 enclosed versions of these drives meet or exceed the specification UL 50-
1995, the Standard for Heating and Cooling Equipment, and complies with the
applicable requirements for installation in a compartment handling conditioned air.
Enclosure Dimensions
Table 16. 230-Volt H9 ASD Systems.
Frame
Model Number
VT130H9U
Enclosure
Figure
Number
A
Width
(in/mm)
B
Height
(in/mm)
C
Depth
(in/mm)
Mounting Hole Dimensions
(in/mm)
Conduit
Plate
D E R1 R2
2
2010
Figure 31
5.2/132 11.2/285 6.1/155 8.7/220 4.5/114
0.098/2.5
0.217/5.5 Figure 34-A
2015
2025
3
2035
6.1/155 12.4/315
6.6/168
9.8/249 5.4/138
2055
4
2080
6.9/175 15.0/381 11.1/283 6.2/158 0.236/6.0 Figure 34-B
2110
5B
2160
9.1/231 19.3/490 7.6/193 15.2/386 8.3/210 0.118/3.0 0.276/7.0 Figure 34-D2220
2270
62330
Figure 32
11.1/283 25.9/658 13.2/335 25.0/635
8.0/203 0.188/4.8 0.375/9.5
Figure 34-E
7B
2400
14.3/363 33.1/841 15.0/381 32.3/820 Figure 35-G
2500
2600
2750
9210K
Figure 33
14.6/371 51.7/1313
17.6/447
50.2/1275 9.2/234
0.344/8.7 0.670/17
Figure 35-I
10 212K 15.7/399 53.1/1349 51.7/1313 9.9/252 Figure 35-J
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
To Next Page
Loading...
