Toshiba HWS-1403XWHM3-E - Page 32

Toshiba XXXXXXX(<SanSerif1>X/X)
–32–
Hydro Unit
Installation Manual
 Setting Function Codes for
Hydro Unit and Remote
Controller
Set function codes for various operation modes with
the remote controller.
There are two types of setting.
1) Hydro Unit function code setting
2) Remote controller function code setting
Setting remote controller mode
<Setting Hydro Unit Function Code>
1 Press the TEST + SET + SELECT
buttons for four seconds or more
to enter the remote controller function code
setting mode.
2 Set the function code (CODE No.) with the
TEMP. buttons. (CODE No.: 01 to
91)
3 Set data (DATA) with the TIME
buttons.
4 Press the SET button to determine the
settings.
5 The CL button is enabled only before the
SET button is pressed and the function
code is changed.
6 Press the TEST button to end the
settings.
<Setting Remote Controller Function Code>
1 Press the TEST + CL + TEMP.
buttons for four seconds or more to enter
the remote controller function code setting
mode.
2 Set the function code (CODE No.) with the
TEMP. buttons. (CODE No.: 01 to
13)
3 Set data (DATA) with the TIME
buttons.
4 Press the SET button to determine the
settings.
5 The CL button is enabled only before the
SET button is pressed and the function
code is changed.
6 Press the TEST button to end the
settings.
+00EF99805101_01EN.book Page 32 Monday, June 21, 2010 3:45 PM