Toshiba HWS-G2601ENXR-E - Replace the PCB Board Standard & Deluxe; Replace the Display & Frame

Domestic Hot Water Heat Pump Service Manual
71
13.15 Replace the PCB board, Standard (1.) & Deluxe (2.)
Tools:
BT20 Torx Screwdriver , terminal screwdriver
1.
Complete steps 13.1
& 13.2, Std PCB
 Although all
cables are identified
for location, take
note of the
conductor colour for
the terminal block
connection
 The PC Board is
held on to the PC
board bracket using
plastic mounts,
pinch to release
 The PC Board
bracket can be
removed by use of a
BT20 Torx
screwdriver
2.
Complete steps 13.1
& 13.2, Deluxe PCB
 Although all
cables are identified
for location, take
note of the
conductor colour for
the terminal block
connection
 The PC Board is
held on to the PC
board bracket using
plastic mounts,
pinch to release
 The PC Board
bracket can be
removed by use of a
BT20 Torx
screwdriver
13.16 Replace the display & frame
Tools:
BT20 Torx Screwdriver
1.
Complete step 13.1
 Unclip the display
frame from the
display by gently
pulling the top edge.
 Using the BT20
Torx screwdriver,
remove the 4
retaining screws
from the panel.








Figure 2 Update to Deluxe PCB