145
To start the operation
1 Press the [ ] button and the [ ] button at same time for 4
seconds or longer on the top screen to display the “FIELD SETTING
MENU”.
2 Press the [ ] / [ ] button to select “Floor drying” on the
FIELD SETTING MENU, then press the [ ] button.
3 Press the [ ] button to select the ON, then press the [ ]
button.
• Check the total days for Floor drying operation, then press [ ] button.
The mark and mark appears on the Top screen.
4 Start the heating operation on the top screen.
• Then ZONE1 mark blinks during Floor drying operation and lapsed days
are displayed.
• If some abnormalities occur during Floor drying operation, the System stops and Alarm history screen is
displayed.
• After heating operation is stopped by operating the remote controller during Floor drying operation, if heating
operation is again started within 30 minutes, Floor drying operation is started from the time of stopping.
Test mode
FIELD SETTING MENU(1/2)
Floor drying
Forced defrosting
Information input
Alarm history
SET
ZONE1 HOT WATER
HEAT/COOL HOT WATER
MON
To Next Page
Loading...
