EasyManua.ls Logo

Toshiba HWT-1101F21SM3W-E - Preparations for Installation; Precautions for Safety; General Safety Precautions; Refrigerant Precautions

Toshiba HWT-1101F21SM3W-E
39 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
– 3 –
Hydro Unit
Installation Manual
3 Preparations for installation
Parts required to connect this product (Common items)
Options required for each function
Category Part
Specification
Quantity
Water piping
Drain cock (for water charge) 1
Isolating ball valves
1"
for service 1"
2
Electrical system
Earth leakage breaker for main power supply 30 mA 1
Earth leakage breaker for backup heater 30 mA 1
Purpose
In the Hydro Unit Purchased part
Part name Model name Part name Prescribed specification
Heating
Radiator(s), Fan coil(s), Under
floor heating
Heating & Cooling
(all rooms)
Fan coil(s)
Heating & Cooling
(partly heating only)
––
Motorized 2-way valve (for
cooling)
Refer to “Control parts
specifications” on page 13.
Interlocking with boiler Boiler
Other power supply.
Signal 12 V input function is
required for boiler.
4 Precautions for safety
General safety precautions
Ensure that all Local, National and International regulations are
satisfied.
Read the “Precautions for safety” carefully before installation.
The precautions described below include the important items
regarding safety – Observe them without fail.
After the installation work has been completed, perform a test run
to check for any problems. Follow the Owner’s Manual to explain
how to use and maintain the unit to the customer.
Turn off the main power supply switch (or breaker) before unit
maintenance.
Ask the customer to keep the Installation Manual along with the
Owner’s Manual.
Refrigerant precautions
If a refrigerant leak is suspected contact the dealer who supplied
the system, in the case of a recharge of refrigerant ask service
personnel for details of the leak and confirmation of the repairs
completed.
Generally the refrigerant does not leak, however, if the refrigerant
should leak into a room and a heater or stove burner in the room
is lit, toxic gas may be generated.
Do not install the system in a location subject to a risk of exposure
to a combustible gas.
If a combustible gas leaks and stays around the unit a fire may
occur.
5-EN 6-EN

Related product manuals