169
4. Auto Curve Setting
•
•
<Procedure> Perform the following when no operation is in progress.
1 Press the [ ] button and the [
] button at same time for 4
seconds or longer on the top screen to display the “FIELD SETTING
MENU”.
2 Press the [
] / [
] button to select “Hydro Unit DN” on the
FIELD SETTING MENU screen, then press the [
] button.
3 Press the [ ] / [
] button to select DN number or Data, then
press the [
] / [
] button to set the value.
4 Press the [ ] button. The set value is registered.
SET
Data
0071
0010
To Next Page
Loading...