171
Auto-Curve temperature shift
•
•
1 Press the [
] / [
] button to select “Auto mode” on the MENU
screen.
2 Press the [
] button for 4 seconds or longer to enter the setting mode. The DN code setting
screen appears.
DN_27: Shifted temperature (Range: -5 - +5, Default: 0)
3 Press the [
] button to select Data value, then press the [
] / [
] button to adjust the
temperature between -5K to +5 K.
4 Press the [ ] button. The set temperature is registered.
Data
SET
To Next Page
Loading...