287
DN Item Details
Factory default
Wall Mouned type
All In One type 2 series
02
03
0001 - 0128 None
08
09
0A
0B
0F
10
11
12
Line address 0001 - 0128 None
13
Indoor address 0001 - 0128 None
14
None
18
19
1A
1B
1D
1E
1F
20
21
22
Not use
23
24
25
26
27
28
29
2B
2D
2E
2F
30
31
33
4
2E30099003
❐3 Setting of the setup data to the memory
The default setup data are stored in the memory of the service main PC board.
1. Press the [ ] button and the [ ] button at same time for at least 4 sec.
“FIELD SETTING MENU” will be displayed on the top of the screen.
2. Press the [ ] / [ ] button to select “Hydro Unit DN” on the
“FIELD SETTING MENU” screen, then press the [ ] button.
3. Press the [ ] / [ ] button to select DN code or Data, then press
the [ ] / [ ] button to change the value.
Press the [ ] button. The set value is registered.
*First, make the initial settings as shown in the table below.
Wall Mouned type
All In One type 2 series
10
Type setting 0070: Wall mounted type
0071: All In One type
Water heat exchanger capacity
(Hydro unit type setting)
0010: 60 0015: 110
0017:140
6B8 Hot w ater supply is using 0000: Yes 0001: No 0000: Yes
6BA
ZONE2 operation is using 0000: No 0001: Yes 0000: No
Depend on type
※Check the model
name of Hydro unit
and set the correct
data.
6BC
Back up heater capacity 0000: 3 kW 0001: 6kW
0002: 9 kW
6BD
Outdoor unit type setting
0000: 401 / 601 0001: 801 / 1101/1401
0002 - 0003: None
Pump P1 ON/OFF cycling (During long
periods of system OFF)
0000: OFF (Until Mar-2023)
0001: ON (From April-2023)
※Set DN[6D1] to "0001" to privent pump lock
Depend on type
※Check the model name of Hydro unit and set
the correct data.
Depend on type
※Check the model name of Hydro unit and set
the correct data.
Depend on Outdoor unit type
※Check the model name of Outdoor unit and
set the correct data.
To Next Page
Loading...