No. skrameR
Fan motor
1.Detachment
1) Following to work of Detachment of , and .
2) Make sure that the fan motor and the propeller fan
stop.
Remove the flange nut from the fan motor and
propeller fan.
• Loosen the flange nut by turning clock wise.
(To tighten the flange nut, turn it counter clockwise)
3) Remove the propeller fan.
4) Following to work of Detachment of
, 1) to 5).
Propeller fanPropeller fan
Fan motorFan motor
Flange nutFlange nut
(Loose it tuning to right)(Loose it tuning to right)
Compressor case thermostat lead
(Black tube)
Clamp filterClamp filter
Fan motor lead fixing rubber
Separate plate
Protrusion/refrigeration
cycle side
Propeller fan
Fan motor
Flange nut
Binding band A4
Binding band A4Binding band A4
(Loose it tuning to right)
[Detail. C][Detail. C]
Clamp filter
[Detail. C]
[Detail.C]
6) Remove the connector for the fan motor lead.
(The clamp filter is removed and used when installing)
7) Remove the fan motor lead from the fixing rubber for
separate plate.
5) Cut the binding band A (Thickness: 1.1 mm,
Width: 2.5 mm) bundling the compressor case thermo-
stat lead.
Pass the binding band
through the hole on the
clamp filter, and then
bundle compressor case
thermostat lead.
Work procedure
Exchange
parts name
To Next Page
Loading...
