IPedge RECOVERY DISK Recovery Procedure
Installation Manual June, 2011 15-7
16. When the Enterprise Linux screen (shown below) appears press the
Enter key.
17. The system will format the hard disk and install the server software.
This can take approximately 25 ~ 30 minutes.
18. When the installation is finished a screen will appear telling you that
the installation is complete the Reboot button on the lower right
corner of the screen will be enabled.
19. Remove the DVD from the server drive.
20. When the disk is out of the drive press the Enter key on the
keyboard.
21. After rebooting the server, you will see the server restarting in the
remote console screen on the remote PC.
22. For IPedge EC servers go to Step 23.
For IPedge EM servers go to Step 29.
23. As soon as you see text begin to appear on the screen press the Del
key on the keyboard every second or two.
24. When the BIOS Setup Utility screen use the cursor control keys to
select Advanced > IPMI and press the Enter key.
25. Use the cursor control keys to highlight OS Boot Watch Dog then,
press the Enter key.
To Next Page
Loading...
