User’s Manual 8-6
Optional Devices
5. Seat the memory module cover in place and secure it with one screw.
Seating the memory module cover
6. Install the battery pack - refer to Replacing the battery pack section in
Chapter 6, Power and Power-up Modes, if required.
7. Turn your computer over.
8. Turn the computer on and make sure the added memory is recognized -
to confirm this select Start Control Panel System and
Security System icon.
Removing a memory module
To remove the memory module, follow the steps as detailed below:
1. Turn the computer off and remove all cables connected to the computer.
2. Turn the computer upside down and remove the battery pack (refer to
Chapter 6, Power and Power-up Modes.)
3. Remove one screw securing the memory module cover.
4. Lift off the memory module cover.
5. Push the latches outward and the memory module will pop up.
6. Grasp the memory module by the sides and pull it out.
7. Seat the memory module cover in place and secure it with one screw.
8. Install the battery pack - refer to Replacing the battery pack section in
Chapter 6, Power and Power-up Modes, if required.
9. Turn your computer over.
Take care to ensure that the memory module cover is firmly closed.
1. Memory module cover 2. Screw
1
2
To Next Page
Loading...
