WHEN REPLACING EEPROM (MEMORY) IC
VCR side EEPROM (IC1001) initial setting
Table 2
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
The unit will now have the correct DATA for the new MEMORY IC.
Turn on the POWER, and set to the TV mode.
Enter DATA SET mode by setting VOLUME to minimum.
Press both VOL. DOWN button on the set and Channel button (7) on the remote control for more than 2 seconds.
ADDRESS and DATA should appear as FIG 1.
Again, Press both VOL. DOWN button on the set and Channel button (7) on the remote control for more than 2 seconds.
ADDRESS and DATA should appear as FIG 2.
ADDRESS is now selected and should "blink". Using the UP/DOWN button on the remote, step through the ADDRESS until
required ADDRESS to be changed is reached.
Press RIGHT/LEFT button to select DATA. When DATA is selected, it will "blink".
Again, step through the DATA using UP/DOWN button until required DATA value has been selected.
Pressing RIGHT/LEFT button will take you back to ADDRESS for further selection if necessary.
Repeat steps 5 to 8 until all data has been checked.
When satisfied correct DATA has been entered, turn POWER off (return to STANDBY MODE) to finish DATA input.
After the data input, set to the initializing of shipping.
Turn on the POWER, and set to the TV mode.
Press both VOL. DOWN button on the set and Channel button (1) on the remote control for more than 2 seconds.
After the finishing of the initializing of shipping, the unit will turn off automatically.
32 02 C6 06 0E 2B 19 55 04 91
+0 +1 +2 +3 +4 +5 +6 +7 +8 +9
+A
+B +C +D +E +FINI
B0 00 01 A3 01 20 37 00 31
00 00 00 00 00 00 00 00
01 B0 98 95 8A A200
10
01
29 04 00 00 23 24
20
ADDRESS DATA
INIT 00 32
PLAY/REC 0000
DECK@ERROR
REEL 00 DRUM 00
MECH 00 CAPS 00
FIG. 2
--- --- --- --- --- --- ---
---
C4-11
To Next Page
Loading...
