Toshiba MW27H63 - Troubleshooting Guide (Continued); VCR Mechanical and Cassette Loading Issues; VCR Tape Loading and DVD Deck Issues

®
1
To turn on the unit, press POWER.
The power indicator will light.
* Every time you turn on the TV, the unit starts from
TV/VCR mode. When you use TVNCR after DVD
operation, press TV/VCR.
POWER PO ER
0 "ii='-
Adjust the volume level by pressing VOL +/-.
The volume level will be indicated on the screen
by green bars. As the volume level increases, so
do the number of bars. If the volume decreases
the number of green bars also decreases.
Set the TV/CABLE selection to the appropriate
position _.
TV - VHF/UHF channels
CABLE - CableTV channels
Press INPUT, Then press _,/_' or Numberbuttons (0 or 1) to select the desired mode
(O: ANALOG MODE, 1 : DIGITAL MODE), then
press ENTER,
CiDC!D
!!!! ii!_!_i_i!ii!ii!ii!ii!ii!ii!ii!ii!ii!ii!ii!ii!ii!ii!ii!ii!ii!ii!ii!ii!ii!ii!ii!ii!ii!ii!ii!ii!ii!ii!ii!ii!ii!ii!ii!ii!ii!ii!ii!ii!ii!ii!ii!ii!ii!ii!_.....
5
Press CH ^/v or Direct channel selection
buttons (0-9) and I button to select the
channel
To change to a
specific channel
(programmed or
unprogrammed):
Press Direct channel
selection buttons (0-9)
on the remote control.
For example, to select
channel 125, press
1,2,5.
To change to a specific digital channel:
Press the first 3 digits, then press i, followed by the
remaining 3 digits. For example, to select channel 015-
001, press 0, 1,5, I, 0, 0, t.
TV Cable TV
VHF VHF
2-13 2-13
UHF STD/H RC/I RC
14-69 14-36
(A) (W)
37-59
(AA) (WW)
60-85
(AAA) (ZZZ)
86-94
(86) (94)
95-99
(A-5) (A-1)
100-125
(100) (125)
01
(5A)
Notes:
* Digital cable channels may be represented by channel
numbers that include a "dash" (e.g., 85-002). These digital
channel numbers may not match the numbers in the channel
line-up provided by your cable company.This is not a
malfunction.
* If a channel with no broadcast is selected, the sound will
automatically be muted.
o
=o
i,
o
221
®
5Y40101A indb 23
÷
23
2'2 _006 : 8 [7AM ]