User’s Manual C-3
Wireless LAN
When installing Wireless LAN cards, the channel configuration is managed
as follows:
■ For wireless clients that operate in a Wireless LAN infrastructure, the
Wireless LAN card will automatically start operation at the channel
identified by the Wireless LAN Access Point. When roaming between
different access points the station can dynamically switch to another
channel if required.
■ In a Wireless LAN Access Point, the Wireless LAN card will use the
factory-set default channel(printed in bold), unless the LAN
Administrator selected a different channel when configuring the
Wireless LAN Access Point device.
*1
Factory-set default channels
*2
Refer to the sheet Approved Countries/Regions for use for the
countries/regions that in which these channels can be used.
To Next Page
Loading...
