4 Replacement Procedures 4.2 Keyboard cover and keyboard
4.2 Keyboard Cover and Keyboard
Removing Keyboard
Remove the Keyboard Cover and keyboard according to the following procedures and Figure
4-4, 4-5, 4-6.
1. Release the following 6 latches on the keyboard cover, in that order:
- One latch on each of the left and right sides
- Four bottom latches
2. Remove two M2.5x10 black flat-head screws and one M2.5 x 5 black flat-head screw.
3. Remove the keyboard cover.
4. Remove two M2 x 4 black flat-head screws.
5. Release the keyboard lock latch.
6. Disconnect the keyboard cable from CN6 on the system board.
7. Remove the keyboard.
M2.5X10 black flat-head screw
M2.5X5blackflat-head screw
Figure
4-4 Removing the keyboard cover and keyboard
4-14 TOSHIBA NB100 Maintenance Manual
To Next Page
Loading...
