4.4 Display Assembly 4 Replacement Procedures
4.4 Display Assembly
Removing the Display Assembly
CAUTION: Use care to avoid that the antenna cable is not caught between the display
assembly and computer.
Remove the display assembly according to the following procedures and Figures 4-8, 4-9.
1. Turn the computer upside down and remove two M2.5x10 black flat head screws.
2. Restore the normal computer placement and open the display panel.
M2.5 X 10 black flat-head screw
Figure 4-8 Removing the screws from the back of the computer
3. Disconnect the LCD/FL cable from CN3 on the system board.
4. Disconnect the Speakers cable from CN7 on the system board.
5. Remove two M2.5x 10 black flat-head screws securing the LCD module to the
bottom cover.
6. Remove the wireless antenna cables, Speakers cable and LCD/FL cable from the
bottom cover.
TOSHIBA NB100 Maintenance Manual 4-19
To Next Page
Loading...
