4.9 LCD Module 4 Replacement Procedures
4.9 LCD Module
NOTE: ICs are fragile. Use extreme care not to apply pressure to the ICs along the
edges of the LCD module.
NOTE: Dispose of used LCD panels (fluorescent (FL) tubes) as required by local
ordinances or regulations.
NOTE: The LCD/FL cable must be carefully peeled away before disconnecting it from
the module.
Removing the LCD module
Remove the LCD module according to the following procedures and Figures 4-19, 4-20.
1. Remove LCM/CCD Cable from CCD Board. Connector.
2. Remove two M2.5 x 5 black flat-head screws on each side securing the LCD bracket.
3. Carefully tilt the LCD module toward you.
4. Remove two M2 x 2.5 black flat head screws on each securing the LCD bracket.
5. Remove the LCD brackets.
M2.5X5blackflat-head screw
M2.5X5blackflat-head screw
LCM/CCD Cable
LCD module
Figure 4-19 Removing the LCD module and screws
TOSHIBA NB100 Maintenance Manual 4-33
To Next Page
Loading...
