Toshiba NB100 - Page 74

3 Diagnostic Programs 3.2 Quick Start
14 TOSHIBA NB100 Maintenance Manual
 Current Time(C. TIME): Current system time, e.g. ‘C.TIME:2008-02-16 00:42:40’ in
the above screen;
 Test Time Remaining (LEFT): In TIMEBOUND mode, it would display the remaining
test time at the same location as Current TIME (C. TIME) in the above screen;
 Current Loop Count: In LOOPBOUND mode, it will display the total LOOP number
planning to execute and the current LOOP number have been finished, e.g. ‘COUNT:
01/01’ in the above screen;
 CPU Temperature: Detect the temperature in the current CPU, e.g. ‘CPU: 56C’ in the
above screen;
 Remaining Battery Capacity: Remaining Battery Capacity detected in the current
Battery, e.g. ‘BAT: 46%’;
 Test Order: Define the test sequence. There is two sequence modes: Sequential Test
Mode and Random Test Mode. The default mode is Sequential Test Mode, it would
displays ‘ORDER: SEQ’ as in the above screen;
 LOG File Name: Display the file name of the test log, e.g. Custom.Log in the above
screen;
 Start Test Time (S.TIME): Display the test start time for the current test item or the test
script, e.g. ‘S.TIME: 2008-02-16 00:42:28’ in the above screen;
 Break On Error: Display ‘HALT’ as shown in the above screen when ‘Break On Error’
is enabled;
 Wait On Error: Display ‘WAIT’ as shown in the above screen when ‘Wait On Error’ is
enabled;
 Pause Enable: Display ‘PAUSE’ when “Pause Enable” is enabled;
 Manual Interrupt Method: Display ‘Esc: Break’ to tell the user how to manually
interrupt the test process.