User’s Manual 7-2
BIOS Setup and Passwords
Password
User Password / Supervisor Password
Select Set User Password / Set Supervisor Password and press Enter,
then the following message is shown:
Set User Password
Enter New Password [ ]
Confirm New Password [ ]
If there is an old password then setup will prompt with following window
instead and a current password will be required to be entered at first:
Set User Password
Enter Current Password [ ]
Enter New Password [ ]
Confirm New Password [ ]
User can type password in the field of Enter New Password, and re-enter
password in the filed of Confirm New Password for verification.
If the verification is correct, the following message is shown:
Setup Notice
Changes have been saved.
[Continue]
The supervisor password is set after user press enter.
If the verification is fail, the following message is shown:
Setup Warning
Password does not match
Re-enter Password
[Continue]
The formats of the password are no more than 8 characters and must be
alphanumeric characters.
If you enter the password incorrectly three times in a row, the computer
need to shut off. You will not be able to access the password option in the
BIOS Setup Menu. In this case you must turn the power off and back on to
retry the procedure.
Starting the computer by password
If you have already registered a password, please enter the password
manually to start the computer:
To Next Page
Loading...
