4 Replacement Procedures Error! Style not defined. Error! Style not defined.
NB200 Maintenance Manual 4-26
9. Lift up the logic upper assembly.
Installing the Logic Upper Assembly
Install the logic upper assembly according to the following procedures.
1. Seat the logic upper assembly to the front of the laptop, and adjust to the correct position.
2. Attach the bluetooth cable.
3. To reconnect the touch pad cable, use tweezers and a finger to push down on the left and
right latches of the connector. Both latches must be pushed simultaneously to secure the
touch pad cable.
4. Secure the LCD display assembly with two M2.5x6 screws and attach the LVDS cable to
the motherboard as shown in Figure 4.16.
5. Close the laptop and secure two M2.5x6 screws as indicated in Figure 4.15.
6. Open the laptop and secure four 2.5x6 screws on the laptop as indicated in Figure 4.13.
7. Route first the WLAN antennas through the trough and then pull through the slot to the
underside of the computer.
8. Route the camera cable, microphone cable and Bluetooth cable through the trough and
secure in the logic upper assembly with adhesive tape.
NOTE: Take extra care in routing cables and antennas on Logic upper assembly. Improperly
routed cables can become pinched or damaged and cause malfunction.
To Next Page
Loading...
