Toshiba nv Series - Page 30

Unified Controller nv Series type1 light Controller Unit Operating Instructions
11
Table 1.8 Mounting slots on the main base unit
Base unit S0 S1 S2 S3 S4 S5 S6 S7 S8 S9 S10 S11
BUM7B PUM12 IO IO IO IO IO IO IO IO IO IO ×
S0 - S11: For mounting modules
PUM12: For mounting PUM12
I/O: For mounting the G2 I/O module
×: Not mountable. Be sure to install an empty module (SP600).
Table 1.9 Mounting slots on the remote base unit
Base unit S0 S1 S2 S3 S4 S5 S6 S7 S8 S9 S10 S11
BUM7B GA922 IO IO IO IO IO IO IO IO IO IO IO
S0 - S11: For mounting modules
GA922: For mounting the G2 I/O adapter module (GA922) (S/N xx1331 or greater)
I/O: For mounting the G2 I/O module
The power supply module is not required for BUM7B which is provided with the built-in
AC power supply. Connect BUM7B to 100/200 VAC from the power supply terminal
block (same as PS361).
(３)既存 T3/T3H のベースユニット
◆Remark
Be sure to install an empty module (SP600) for the slot which does not contain a
module.
◆Remark
Be sure to install an empty module (SP600) for the slot which does not contain a
module.