Unified Controller nv Series type1 light Controller Unit Operating Instructions
73
3.1 Installation Condition
Install the type1 light controller and related products in T series migration system onto the
indoor control panel openable and closable by the administrator, within each general
specification range. The type1 light controller's installation environment shall meet the
condition in the following table.
For the type1 light controller see the unified Controller nv Series type1 light Controller Unit
User’s Manual (6F8C1497).
Caution
Do not install/store/use the device in the following
environments:
• A place with a lot of dust
• A place with corrosive gases (SO2, H2S) or flammable gases
• A place with vibrations and shocks exceeding the allowed
values
• A place with condensations due to a sudden temperature
change
• A place with low or high temperature outside of the installation
condition
• A place with high humidity which is outside of the installation
condition
A place exposed to direct sunlight
• A place near any equipment generating intense radio wave or
magnetic field
This may cause accident.
Prohibited
To Next Page
Loading...
