Chapter 2 Installing/Uninstalling
6F8C1575
30
■Procedure to install the controller module
(1) Turn off the power of the type2 light controller.
Also turn off the external power supply to the I/O module.
(2) Mount the base unit on the vertical panel of the control board.
(Refer to 2.4 “Installing the Base Unit.”)
(3) Confirm the slot for mounting the base unit of the module.
(4) Align the leads of the module to the upper and
lower slot guides of the base unit.
(5) Hold the upper and lower parts of the module
tight and press the module into the
perpendicular base unit slowly and securely.
Leads of the module
Slot guides
To Next Page
Loading...
