Chapter 2 Installing/Uninstalling
6F8C1575
34
■Procedure to install the serial bus interface module
(1) Turn off the power of the type2 light controller.
Also turn off the external power supply to the I/O module.
(2) Mount the base unit on the vertical panel of the control board.
(Refer to 2.4 “Installing the Base Unit.”)
(3) Confirm the slot for mounting the base unit of the module.
(Refer to Figure 2-4 Module slots.)
(4) Align the leads of the module to the upper and
lower slot guides of the base unit.
(5) Hold the upper and lower parts of the module
tight and press the module into the
perpendicular base unit slowly and securely
until the upper and lower lock levers are set
on the base (a clicking sound is heard).
(6) Tighten the M4 screw at the top of the
mounting hole to secure the module to the
base unit.
(Recommended tightening torque: 1.47 N
・
m
= 15 kgf
・
cm)
(7) Connect the required cables.
Remark
(1) Remove the connector cover, provided at the factory for shipment, to connect the
cable.
S
Leads of the module
To Next Page
Loading...
