Chapter 5
Downloading a Program
6F8C1575
56
Download programs to the controller unit according to the following procedure.
Connect nV-Tool to the controller unit.
Connect it directly via USB to controller module or via the control LAN.
Set communication with the controller unit with nV-Tool.
About the setup method, please refer to nv-Tool setup manual (6F8C1291)
「
Section2 Setup V-tool
」
Change the operation mode of the controller unit to HALT (halt condition).
Click the appropriate station from [Product tree] of nV-Tool with a mouse and click
<File> and <Download> in the menu.
The download start screen is displayed.
Select “Batch download/divided download”.
・
Please confirm again that the download program has no
problems.
・
Do not download the wrong program. It may cause
malfunction or the system error down.
・
Please confirm again that controller which program will be
downloaded is the assignment controller.
CAUTION
Mandatory
To Next Page
Loading...
