Toshiba nv Series - Changing the operation mode using the operation mode key switch; Monitoring the status with the controller status display LED

Chapter 6 Operation
6F8C1575
62
■ Changing the operation mode using the operation mode key switch
Table 6-1 Changing the operation mode key switch
Switch position
Operation
HALT
Selecting HALT from other position changes to the HALT mode.
If you turn on the power in the HALT condition, the controller starts
in the HALT mode. Operation mode change from nV-Tool is not
accepted.
RUN
Selecting RUN from HALT changes to the RUN mode.
Operation mode change from nV-Tool enables the HALT mode.
P-RUN
The operation status is the same as RUN.
Writing to the entire program is forbidden.
■ Monitoring the status with the controller status display LED
Monitor the operating status of the controller with the controller status display LED.
Table 6-2 Controller status display LED
Name
Color
Meaning
Remark
LED
RUN
Green
ON
Normal operation
RUN
S
tatus
PU board
Flash
− −
OFF
Operation stopped.
HALT/ERR/DL
-
WAIT
S
tatus
ONL
Green
ON
Online in duplex operation
MAS
-
RUN
S
tatus
Flash
Equalization being sent.
EQL
-
RUN
S
tatus
OFF
− −
STBY
Green
ON
Standby in duplex operation
SLV
-
RUN
S
ta
tus
Flash
Equalization being received.
RCV
-
H
S
tatus
OFF
− −
HALT
Green
ON
Operation halted.
HALT
S
tatus
Flash
DL waiting
DL
-
WAIT
S
tatus
OFF
− −
ERR
Red
ON
Stopped due to error
ERR
S
tatus
Flash
− −
OFF
− −
ALM
Yellow
ON
Minor f
ailure (e.g. congestion,
fallback)
ON for each error (failure)
detected/ recovered
(OR of minor system failure)
Flash
−
OFF
Normal
BATT
Green
ON
Normal battery voltage
ON during initialization
diagnosis and scheduled
diagnosis
Flash
Abnorma
l battery voltage
OFF
Battery not mounted.
TRK
Green
ON
Duplex tracking in progress
(sending/receiving)
ON by HW
OFF
−
LP
Green
ON
TC
-
net I/O in loop connection
ON by HW
OFF
SCAN
Green
ON
TC
-
net I/O in scan transmission
ON by HW
OFF
−
TRUN
Green
ON
FN board is operating.
FN board
Flash
−
OFF
FN board is not operating.
HLTH
Green
ON
Network parameters are
correct.
Flash
−
OFF
Network parameters are
incorrect.
The green light indicates a normal condition, the yellow light indicates light error condition, the red light
indicates an abnormal condition in principle. The light-off indicates that there is nothing applicable. No
green light turned on indicates an error regardless of whether a red light is turned on or not.
RUN
HALT
ONL
STBY
BATT
TRK
ERR
ALM
LP
SCAN
TRUN
HLTH