268 P9 ASD Installation and Operation Manual
Enclosure and Conduit Plate Dimensions
The P9 ASD part numbering convention is shown below.
P9
Part Numbering Convention.
The enclosure dimensions for the available models (typeforms) are listed in Tables 17 and 18. The conduit
plates referenced are shown in Figures 41, 42, and 43.
Note: The Type 1 enclosed versions of these drives meet or exceed the specification UL 50-
1995, the Standard for Heating and Cooling Equipment, and complies with the
applicable requirements for installation in a compartment handling conditioned air.
Enclosure Dimensions
Table 17. 230-Volt P9 ASD Systems.
Frame
Model Number
VT130P9U
Enclosure
Figure
Number
A
Width
(in/mm)
B
Height
(in/mm)
C
Depth
(in/mm)
Mounting Hole Dimensions
(in/mm)
Conduit
Plate
D E R1 R2
2
2010
Figure 38
5.2/132 11.2/285 6.1/155 8.7/220 4.5/114
0.098/2.5
0.217/5.5 Figure 41-A
2015
2025
3
2035
6.1/155 12.4/315
6.6/168
9.8/249 5.4/138
2055
4
2080
6.9/175 15.0/381 11.1/283 6.2/158 0.236/6.0 Figure 41-B
2110
5B
2160
9.1/231 19.3/490 7.6/193 15.2/386 8.3/210 0.118/3.0 0.276/7.0 Figure 41-D2220
2270
6 2330
Figure 39
11.1/283 25.9/658 13.2/335 25.0/635
8.0/203 0.188/4.8 0.375/9.5
Figure 41-E
7B
2400
14.3/363 33.1/841 15.0/381 32.3/820 Figure 42-G
2500
2600
2750
9 210K
Figure 40
14.6/371 51.7/1313
17.6/447
50.2/1275 9.2/234
0.344/8.7 0.670/17
Figure 42-I
10 212K 15.7/399 53.1/1349 51.7/1313 9.9/252 Figure 42-J
To Next Page
Loading...
