Toshiba P9 - Page 285

306 pages

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

P9 ASD Installation and Operation Manual 275

Figure 43. See Table 18 for the associated device. Dimensions are in in/cm.

Table of Contents

Default Chapter9
- Table of Contents9
General Safety Information11
- Safety Alert Symbol11
- Signal Words11
- Special Symbols12
- Equipment Warning Labels12
- Qualified Personnel12
- Equipment Inspection13
- Handling and Storage13
- Disposal13
Installation Precautions14
- Location and Ambient Requirements14
- Mounting Requirements14
- Conductor Routing and Grounding Precautions15
- Power Connections Precautions16
- Protection16
System Integration Precautions17
- Personnel Protection17
- System Setup Requirements18
Operational and Maintenance Precautions19
Motor Characteristics20
- Motor Autotuning20
- Pulse Width Modulation Operation20
- Low-Speed Operation20
- Overload Protection Adjustment20
- Operation above 60 Hz20
- Power Factor Correction21
- Light Load Conditions21
- Motor/Load Combinations21
- Load-Produced Negative Torque22
- Motor Braking22
P9 ASD Characteristics23
- Over-Current Protection23
- P9 ASD Capacity23
- Using Vector Control23
Installation and Connections24
- Installation Notes24
- Mounting the ASD25
- Connecting the ASD26
- Lead Length Specifications30
- I/O and Control31
Electronic Operator Interface38
- EOI Operation38
- Battery Backup38
- EOI Remote Mounting39
- EOI Features39
- EOI Remote Mounting42
System Operation45
- Operation (Hand)45
- Default Setting Changes46
- Save User Settings47
Command Mode and Frequency Mode Control48
- Command Control (F003)48
- Frequency Control (F004)49
- Override Operation50
System Configuration and Menu Options53
- Root Menus53
Virtual Linear Pump Setup83
Direct Access Parameter Information87
- Direct Access Parameters/Numbers87
Alarms, Trips, and Troubleshooting266
- Alarms and Trips266
- User Notification Codes267
- Alarms268
- Trips/Faults271
Enclosure and Conduit Plate Dimensions278
- Enclosure Dimensions278
- Conduit Plate Dimensions283
Current/Voltage Specifications286
Cable/Terminal/Torque Specifications288
Dynamic Braking Protection290
Short Circuit Protection Recommendations292
P9 ASD Optional Devices293

Related product manuals

Toshiba PROSEC T1

Preview: Toshiba PROSEC T1-16S

Toshiba PROSEC T1-16S

Toshiba 3000 PROFIBUS

Preview: Toshiba P9 ASD

Preview: Toshiba TDP-P9

Preview: Toshiba S15

Preview: Toshiba CONNECT

Toshiba CONNECT

Preview: Toshiba 40 Plus

Toshiba 40 Plus

Toshiba V Series

Preview: Toshiba TE2 Series

Toshiba TE2 Series

Preview: Toshiba BMS-CT5121E

Toshiba BMS-CT5121E