42 P9 ASD Installation and Operation Manual
7 — Communication Option Board
Use this setting if using the optional Communication Board for frequency control.
8 — RX2 Option (AI1)
Used for a -10 to +10-volt DC analog input signal.
9 — Option V/I
Allows for the use of the optional voltage/current frequency-control interface.
10 — UP/DOWN Frequency
A discrete terminal may be configured to increase or decrease the speed of the motor by
momentarily connecting the assigned discrete input terminal to CC. See F264 on pg. 129 for
further information on this feature.
11 — Pulse Input Option
Used to allow the system to use a pulsed input for frequency control. See PG Input Point 1
Setting on pg. 123 for further information on this feature.
12 — Pulse Input (motor CPU)
Used to allow the system to use a pulsed input for frequency control. See PG Input Point 1
Setting on pg. 123 for further information on this feature.
13 — Binary/BCD Input Option
Allows for discrete terminal to be used for frequency-control input.
To Next Page
Loading...
