Toshiba PA912 - Page 45

3.2 Setting the Slave Device Configuration Information
Unified Controller nv series PROFIBUS(PA912) Module Instruction Manual
33
Refer to the Anybus NetTool-PB Instruction Manual for the installation method
and detailed usage instructions of the PROFIBUS configurator tool.
This chapter explains a simple operation method for registering the PROFIBUS
slave I/O devices with the use of the Anybus NetTool-PB. The following
description is based on the case where the Anybus NetTool-PB ver. V1.6.1.1 is
used. When screens or setting methods have been changed due to the upgrade,
etc. of the configurator software, refer to the instruction manual of the
configurator tool.
Note that the explanations are given according to the following configuration.
Figure 3-5 System configuration and setting example
PU811
RP913
PA912
1794-APB
［1］
1794-IB16
［2］
1794-IB16
［3］
1794-OB16
［4］
1794-OB16
［5］
Allen-Bradley FLEX I/O
Input Adr
=2..3
Slave Adr
=3
Input Adr
=128..129
Output Adr
=2..3
Output Adr
=128..129
Reception block (high speed)
Reception block (medium speed)
Transmission block (medium speed)
RAS information
Input area
128
2
1536 bytes
Output area
128
2
1536 bytes
IB16 input
OB16 output
■TC-net I/O loop address=3
■PA912 module parameter
・High-speed scan byte size (output) = 128
・High-speed scan byte size (input) = 128
■PROFIBUS master address=1
Registration of the
PROFIBUS slave devices
explained in this chapter
Reception block (medium speed)
Transmission block (high speed)