3.2 Setting the Slave Device Configuration Information
Unified Controller nv series PROFIBUS(PA912) Module Instruction Manual
39
3
Register a slave node.
To register a slave node, select the slave node in the left portion of the main
screen, and drag and drop it to the upper portion of the [bus configuration 1]
area.
Figure 3-11 Slave node registration (1)
◆
◆◆
◆Important
・
Set within the range of 3 to 125 for the PROFIBUS address of the slave node. If the value
out of the range is set, the configuration import to the nV-Tool described in “3.3 Setting with
the Engineering Tool” will not be available.
Drag and drop
To Next Page
Loading...
