3.19 Log Utilities 3 Tests and Diagnostics
Portege 2000 Maintenance Manual (960-333) 3-45
3.19.2 Operations
Selecting 5-LOG UTILITIES and pressing Enter in the DIAGNOSTIC MENU logs error
information into RAM or onto a floppy disk. The error information is displayed in the
following format:
0003 ERRORS
CNT TS-No PASS STS ADDR WD RD HSTS [ERROR STATUS NAME]
001 FDD 01 0000 110 24015 00 00 FDD-CRC ERROR
002 FDD 01 0001 110 30108 00 00 FDD-CRC ERROR
003 FDD 03 0003 110 23106 00 00 FDD-CRC ERROR
[[1:Next,2:Prev,3:Exit,4:Clear,5:Print,6:FD Log Read,7:FD Log Write]]
2. The error information displayed on the screen can be manipulated by the following
number keys:
The 1 key scrolls the display to the next page.
The 2 key scrolls the display to the previous page.
The 3 key returns to the Diagnostic Menu.
The 4 key erases all error log information in RAM.
The 5 key outputs the error log information to a printer.
The 6 key reads the log information from a floppy disk.
The 7 key writes the log information to a floppy disk.
3. In the case of “error retry OK,” a capital “R” will be placed at the beginning of the
error status. However, it is not added to the error count.
Error status name
Error count
Pass count
Error status
Subtest number
FDD/HDD or
memory address
Test name
Read data
Write data
HDC status
To Next Page
Loading...
