4.3 Memory module 4 Replacement Procedures
Portage 2000 Maintenance Manual (960-333) 4-13
Installing the memory module
To install the memory module, confirm that the computer is in boot mode. Then perform
the following procedure (See Figure 4-3,4-4)
1. Install the memory module to the main board and secure it with the following
screw.
• M2×3S S-THIN HEAD screw x1
Caution: The power must be turned off when you insert the memory module. Inserting
a memory module with the power on risks damaging the module or the
computer itself.
Never press hard or bend the memory module.
2. Install the memory slot cover.
3. Secure the following screws to fix the memory slot cover.
• M2×2.5B SPECIAL HEAD screw x2
To Next Page
Loading...
