4 Replacement Procedures 4.5 Keyboard/Bottom cover
4-18 Portage 2000 Maintenance Manual (960-333)
3. Insert your nails in the slot of the right topside and left topside of the keyboard
holder and lift it up to remove.
4. Remove the following screws fixing the keyboard.
• M2×3S S-THIN HEAD screw x2
PJ445
Keyboard holder
M2
×
3S S-THIN HEAD
Figure 4-9 Removing the keyboard holder
5. Pick up the top of the keyboard to the front and disconnect the flexible keyboard
cable from PJ445 on the main board.
Installing the keyboard
The following describes the procedure for installing the keyboard (See Figure 4-8,4-9).
1. Connect the flexible keyboard cable to PJ445 on the main board.
2. Install the keyboard and secure it with the following screws.
• M2×3S S-THIN HEAD screw x2
3. Install the keyboard holder.
4. Close the display
5. Install the bottom cover and secure it with the following screw.
• M2×3B S-THIN HEAD screw x1
To Next Page
Loading...
