4 Replacement Procedures 4.6 Speaker/ RTC battery
4-22 Portage 2000 Maintenance Manual (960-333)
4.6 Speaker/ RTC battery
4.6.1 Speaker
Removing the speaker
The following describes the procedure for removing the speaker (See Figure 4-12,4-13).
1. Peel off the three glass tapes fixing the RTC battery cable, speaker cable and
MDC cable.
Figure 4-12 Removing the glass tapes
2. Remove the speaker cable from the connector PJ10 on the main board and remove
the speaker rubber holder from the speaker slot.
3. Remove the speaker from the rubber holder.
Speaker
Rubber holder
Speaker slot
Figure 4-13 Removing the speaker
To Next Page
Loading...
