4.6 Speaker/ RTC battery 4 Replacement Procedures
Portage 2000 Maintenance Manual (960-333) 4-23
Installing the speaker
The following describes the procedure for installing the speaker (See Figure 4-12,4-13).
1. Set the speaker in the rubber holder.
2. Install the speaker rubber holder on the speaker slot and connect the speaker cable
on the PJ10 on the main board.
3. Stick the three glass tapes to fix the RTC battery cable, speaker cable and MDC
cable.
4.6.2 RTC battery
Removing the RTC battery
The following describes the procedure for removing the RTC battery. (See Figure 4-14)
1. Disconnect the RTC battery cable from the connector PJ790 on the main board
and remove the RTC battery from the RTC battery slot.
Figure 4-14 Removing the RTC battery
Installing the RTC battery
The following describes the procedure for installing the RTC battery (See Figure 4-14).
1. Install the RTC battery in the RTC battery slot and connect the RTC battery cable
to the connector PJ790 on the main board.
To Next Page
Loading...
