4 Replacement Procedures 4.9 Main board/ FAN
4-30 Portage 2000 Maintenance Manual (960-333)
4.9.2 FAN
Removing the FAN
The following describes the procedure for removing the FAN. (See Figure 4-20)
1. Remove the FAN cable from the connector PJ780 on the main board.
2. Remove the following screws fixing the FAN.
• M2×4Z BIND screw x3
M2×4Z BIND
PJ780
Figure 4-20 Removing the FAN
Installing the FAN
The following describes the procedure for installing the FAN. (See Figure 4-20)
1. Install the FAN and secure it with the following screws
• M2×4Z BIND screw x3
2. Install the FAN cable to the connector PJ780 on the main board.
To Next Page
Loading...
